Return to Index  

Slo Cure CA

September 18 2007 at 4:57 AM
Glen the Rotorhead  (no login)
from IP address 132.228.195.206


Response to What kind of glue can I use for

I use ZAP slow cure (green bottle). Soften the viny with a hair dryer, apply a few small drops and press the parts together. Best to hit it with some accelerator. Once everything is tack-glued, you can run a bead all the way around (make sure the accelerator has completely dried first or you won't get good penetration.) Then spray with accelerator again.

These joints will hold up to most anything except being dropped, especially when cold. If you want to be really safe, fill the parts with plaster and use pieces of coat hanger with epoxy to make the joints more permanent. Make sure not to add plaster too fast as it builds up a lot of heat - like don't try to fill the whole model in one pour.

Good luck!

 
 Respond to this message   

Please note a few points of etiquette. First, would all contributors please use their real name and/or their actual e-mail address. All contributions are welcome but please refrain from political or abusive comments. These posts will promptly be removed from the server.

In addition, Figuratively Speaking is not a forum for the public criticism of the models that appear as Galleries or Articles. Please make any suggestions for improvements or criticism direct to the author via the email link at the bottom of the Article.

free counters