Right light dim Left light ok '53 2R11 Commander Motor
by
The above occurs no matter whether it is the high beam and low beam. I measured the voltage at the right terminal block and it is 3-4 volts. At the left terminal block there is 7+ volts. I switched the right to the left side and and it works fine, so the sealed beams are good. I cleaned all connections at the plug, disconnected all the connections at both terminal blocks and cleaned and reconnected. I jumpered across from the terminal block on the left side to the right side, same problem. I took the dimmer switch out and wired around it and there is still the same problem. My only guess now is if the actual plug at the light but that doesn't make sense because of the lower voltage. Any other ideas would be appreciated.
Thanks for your time.
Rob Lund
Posted on Mar 17, 2012, 2:05 PM from IP address 65.28.4.95