M16 Drag Link

by

 

Does anyone know what the length of the drag link should be on an M16? I am interested in the length from the outer end of the link (not to the center of the ball on the steering arm,) but to the very end of the shaft, to the center of the tie rod end on the pitman arm end. I had my link modified to accept a replacement tie rod end with about 2" of adjustment,and I would like to know what the original length was. I can adjust it by setting the wheels straight and centering the steering gear but I would like to know this to establish a starting point. The end had been replaced before by butt welding a tie rod end to it so I don't know if that was set at the proper length or not. If anyone is interested I'll post a photo of the modified shaft soon. Thanks.

Roger List



Posted on May 23, 2012, 2:26 AM
from IP address 24.9.109.114


Respond to this message

Goto Forum Home
Responses

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement