First off, you'll need to

by

 

remove the inside window frame first and then the window glass. Then you can remove the regulator. It helps to remove the guide also. Not must to do about the regulator itself. Clean up, paint, and grease. You could try tightening up the rivets but if the teeth are striped then you'll need a new regulator. I just did mine and they now work great. I just have a few issues like the glass is to tight against the wing window and it hangs up on the wing window frame rolling it up. I'm going to let the new cat whiskers and rubber wear in a little more before I tackle that.



Posted on Jun 24, 2012, 10:45 PM
from IP address 71.178.187.52


Respond to this message

Goto Forum Home
Responses

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement