Bo, I thought about putting a bronze bushing in these to eliminate the need to ever repair them again but the inner part of the hinge is drilled really close to the edge as you well know. I found a source for oversized pins that are, if I remember correctly, about .040" over size. I have tried to figure out how to put a zerk fitting or some way to grease them in to no avail yet.
Yes, I do plan on making a jig to drill out the "door half" of the hinge. That should be pretty easy, due to the fact that all of them are the same no matter upper or lower. I will get pictures up as soon as I get a chance to get it built.
Posted on Jun 27, 2012, 11:23 AM from IP address 18.104.22.168