7E and 8E use a 57 1/16" length. It's also a fine spline, so I am guesssing 32 based on your post. I just spent some time weighting the bed down and measuring, then unloading and jacking it up. The shaft I bought is simply too long, and would need at least 1/2" cut off, plus new U joints (Spicer versus mechainics) and then would these u joints fit the yoke on the trans? I dunno.
So I still need a driveshaft for a 6 cylinder T-90 OD Champ, preferably a '62-64, since they all have the same part number.
Thanks@
Posted on Jul 22, 2012, 2:59 PM from IP address 64.147.222.129