Re: Commander 6 timing Cover Seal

by 2R5

 

I have done a couple of things in the past and I have found the easiest fix or at least a great improvement is to just replace the felt seal but before putting your new seal in drill about a 1/4 in hole in the bottom of the part that holds the seal in . This will let oil that accumulates in this part drain back into the engine . If you look at the cover where the seal sits you can see that once the seal is completely oil saturated the oil has only 2 choices to go , either out the front or out the back , this hole will drastically help direct oil back into the engine before it gets to the top and leave through the front.
Hope you can figure out what I'm trying to say



Posted on Aug 12, 2012, 10:05 AM
from IP address 50.70.40.119


Respond to this message

Goto Forum Home

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement