Stake Bed

by John Weinrich

 

Keith, yes looks like it was completed in November of 2012. So it was in VA from that time until April of 2015 and from April of 2015 to present here in OR. I don't recommend ship-lap as thick as mine (1-7/8") because of the weight (heavy stuff). I would have to say that it has held up well. Nearly all the time in VA it was outside, here in OR mostly under a car port. I do coat it with a penetrating stain made especially for hardwoods once or twice a year. The deck was made from Apitong hardwood from Southeast Asia:https://www.trailerdecking.com/Products.aspx?FilterstoAdd=523 . I also used SS grabbers to mount it. Very little cupping. only one board that has a little separation about 12" long and 3" wide. My plan was to eventually go over it with a sander when it got bad but it is far from that state. My guess is that I will never have to sand it or replace it. I also made the stakes from the same wood by ripping the boards in half. For the most part they have stayed true but one or two have warped a little. I have a couple to replace because I backed into some railing at the land fill. All in all I would definitely go this route again but with much thinner boards although the thicker boards allowed me to make the stake posts using the same wood.

http://studem15a-20.blogspot.com/2012/08/the-lone-bed-board.html



Posted on Jun 3, 2017, 9:15 AM
from IP address 208.74.128.1


Respond to this message

Goto Forum Home
Responses

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2017 Network54. All rights reserved.   Terms of Use   Privacy Statement