spreading tool is probably needed

by Gary P.

 

at least that is true for 44's 60's, and 70's. I have the tool and have done a Dana 60 and Dana 70 with it. The bearing preload is set by shims as I recall and spreading the case is the recommended way to get them in properly. You should find the procedure in a shop manual, I believe I used the 70 Dodge Truck shop manual as that's what I was working on. Tool is not really that expensive if you consider what could happen if you mess it up. My tool and all my differential parts came from Randy's ring and pinion.



Posted on Jun 6, 2017, 8:47 PM
from IP address 207.136.208.194


Respond to this message

Goto Forum Home

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2017 Network54. All rights reserved.   Terms of Use   Privacy Statement