Re: Dimension for cam shaft timing gear puller

by ted


Robert it may serve you best to find another camshaft gear these gears do fail and it would be better to find out now if it will fail. Take a drill and make a hole for a 3/8 tap. tap all the way through two of the spokes opposite each other and use a bolt puller the get the gear off the shaft. There is a chance you will damage the gear but with any other method you will damage the gear for sure. That is unless you have a floor press, then you chance damaging the threads in the cam shaft or the retainer.

Posted on Jun 9, 2017, 11:37 PM
from IP address

Respond to this message

Goto Forum Home

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement