Lost part of above post

by Skip Lackie

 

Which was that the installation of a Stude V8 in your truck would be MUCH easier if you had a V8 parts truck to swap parts from. There are lots of items that are different, including radiator, motor mounts, clutch and throttle linkage, trans input shaft, front springs, drive shaft length, etc. A rusty V8 parts truck might cost a few hundred dollars, but would save you a lot in learning, parts, and fabrication.



Posted on Dec 4, 2017, 5:26 PM
from IP address 100.15.195.80


Respond to this message

Goto Forum Home

Find more forums on TrucksCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement