Hi everyone,

I've cut in my hairpiece using a Robocut for the first time and it worked pretty well. It took some time but the result is pretty okay.

Now, the problem is that the density on the sides and back is a bit too much, so it looks a little like the piece hair is lying over my natural hair, so the blend is not very good.

I read much about using thinning shears and a razor comb to tackle such a problem. I just got these two from Debbie and I did a search on the forum (thanks for the google search tip Snipe) but unfortunately I didn't find that much.

So, how do I use the thinning shears and the razor comb to thin out the hair on the sides and back to achieve a better blend with my natural hair?

Any support is greatly appreciated.

Thanks,

Peverel

Okay, I'm a newb, so my advice isn't worth much, but if the hair on your sides is that thick, perhaps you could do with more density on the top?

- Darius

No, the problem is actually that the density of the hair system hair on the sides and back is too much. I would like to thin out the sides and back of the hair system hair.

I read that the thinning shears and razor comb is used for that, I just don't know how to use them...

So, does anybody have any experience with using them? Please let me know how to use them.

Thanks,

Peverel

Click on the first link, follow directions for the next two links and send a thank-you to Snipe. Easy as 1,2,3

http://www.network54.com/Forum/241571/thread/1210881987/last-1214360589/Search+this+forum-How+to

blending shears site:http://www.network54.com/Forum/241571

razor comb site:http://www.network54.com/Forum/241571

buckeye