My air source is leaking from the o-ring between the adapter for the air can and the valve body. I've tried replacing the o-ring and using loctite but it still leaks. When I tighten a new air source can the adapter will unscrew slightly and start to leak. The o-rings I've found aren't quite the right size. They seem to be a bit softer than the original. They get squeezed out slightly and split on one side. Anyone have a source for the o-rings or another solution I could try?

Click on the link below. They have parts diagrams and a lot of the parts for several Crosman guns (and several other manufacturers).

Check to see if your AirSource assembly has any nicks, burrs or anything else that may be interfering with the seal. Also, you should use 1 or 2 drops of oil on your O-rings when replacing them.


http://www.chambersgunmakers.co.uk/