Click logo to enter advertiser's site

 Return to Index  

Re: AOD to c-4 conversion issues

April 11 2012 at 4:10 AM
***no login***  (no login)
from IP address

Response to AOD to c-4 conversion issues


1) You must use a separator plate (block plate) between the bell and motor. If you don't, your starter will eventually break your bell housing.

2) If you bolted the converter to the flexplate BEFORE you seated the converter in the transmission, you probably ruined your pump. Converter must be seated in the transmission BEFORE you lift the transmission to bolt it to the motor. Converter bolts are the LAST bolts to be installed.

3) Turning the driveshaft tells you nothing. The output shaft is not connected to the input unless the motor is running and the transmission is in gear.

 Respond to this message   

Find more forums on CarsCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement