badshoe.jpg
Click logo to enter advertiser's site
 

 Return to Index  

Re: More Info

May 31 2012 at 7:48 PM
Stuart Anderson  (Login stuart40a)
Forum Moderator
from IP address 71.17.81.131


Response to More Info

 

"During the rebuild, I took out the large rear ball bearing in the tail housing for inspection. I thought that I had put it back in backwards and was driving the output shaft too far forward. This turned out not to be the case."

There is a washer on both sides of the rear bearing. One is thicker.

If you have it in the wrong position it could push the output shaft forward.

 
 Respond to this message   
Responses

Find more forums on CarsCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement  
bp.jpg