Click logo to enter advertiser's site
 

 Return to Index  

fmx

July 27 2012 at 6:34 PM
truck doctor  (no login)
from IP address 65.93.161.11


Response to FMX extra clutch plates?

 

up until last year i used the fmx exclusively for drag racing . 4500 stall boss hog convertor with a shift kit, fuly auto tweeked to shift at 6500rpms. it ran great with the exception of the intermidiat band .we had to reinforce the actuator end as it was distorting. clutch plates you can eliminate the bellveld washer and you may have room for a added clutch.you may need a thiner snap ring. this is all depending on the stack hight.these are tough trany's. we swapped to a c4 combo witch by the way pars are a plenty, 4500 convertor same hp same gear lowered the et by .500 thats on half seconds.i personaly like the fmx because all the guts come out the back.no need to remove the trany for overhaul.eather way maintenance is key and refreshing the trany is important if your using it for drag racing. good luck

 
 Respond to this message   
Responses

 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement