Click logo to enter advertiser's site
 


  << Previous Topic | Next Topic >>Return to Index  

Race C6 lube mods?

February 7 2010 at 11:59 PM

  (Login machstang70)
from IP address 68.57.57.18

 
Are there any lube mods to a C6 that I can make? It has a fixed(check balls) TCI transbrake, w/E4OD gear set, 5 red alto's in each pack(dir.,for.,rev.), 2 1/4" Kevlar rigid band, "R" servo, "E"lever, I've heard something about the direct hub for high rpm(8000)? Does anyone ever drill the OD of the forward hub or will it weaken it? Also while I'm at it should I use teflon coated pump gears and a wide rear housing bushing. I'm a machinist so that's not a problem. Mike

 
 Respond to this message   
AuthorReply


(Login machstang70)
68.57.57.18

Any help? Frank?

February 11 2010, 10:02 PM 

Any info would help. Not a reference to a trans shop.

 
 Respond to this message   
gregaust
(no login)
203.143.247.76

Re: Race C6 lube mods?

February 12 2010, 4:20 AM 

http://www.460ford.com/forum/showthread.php?t=113120

That link may help. Not really any lube mods necessary. No bleed hole is required in the drum to stop centrifugal reply. The high reverse drum can have holes drilled around it though . I think it is mentioned in the link above a series of small holes . I recently built a transbrake C6 to Franks specs with his valvebody so looked into most of this myself. Few pics on page 2 http://www.429-460.com/transmission-tech-f7/rebuilding-a-c6-t2255.htm

 
 Respond to this message   


(Login machstang70)
68.57.57.18

Re: Race C6 lube mods?

February 12 2010, 9:35 PM 

Thanks I have senn the sticky post and others on that forum. Good pics on your build! No new info for me, But thanks alot. Mike

 
 Respond to this message   
Current Topic - Race C6 lube mods?
  << Previous Topic | Next Topic >>Return to Index  
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement