Re: express trouble

by (Login themopedwhiz)
Moped Gurus

 

casey

the screw holds the pin that acts like a hinge pin for the float.. i have never seen one over tighten but anything is possible..

check the inlet port where the gascomes into the carb..
make sure it isn't restricted with varnish.. check the fuel petcock to make sure fuel is flowing into the carb. and check the needle seat (tiny port/hole) where the float needle point lets the gas into the carb

TheMopedWhiz

Ride Mopeds, Have Fun , Save Money



Posted on Nov 8, 2003, 8:56 AM
from IP address 151.144.164.78

Respond to this message

Goto Forum Home

Find more forums on MotorcyclesCreate your own forum at Network54
 Copyright © 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  

Member of the Moped webring
Moped webring Homepage