Re: crankcase problem

by (Login themopedwhiz)
Moped Gurus

 

OK..

lets assume that you didn't remove the tranny cover or touch any ajustments, like the tranny release lever by the carb or tighten the rear brake..

that would mean that your new piston and cylinder are too tight / have too much friction... or you have really way too much compression..

did you oil evrything when you put it togethere
the rings, the piston, the piston/rod pin..

you where careful with the cylinder alignment so the piston is centered, the cylinder isn't a fraction off center.. pinching the piston..

me.. i would pull the cylinder off..

MAKE sure the tranny spring is released or you damage something or get hurt.. like a broken finger

TheMopedWhiz

Ride Mopeds..SAve Gas..Have Fun



Posted on Mar 27, 2004, 6:00 PM
from IP address 151.144.164.58

Respond to this message

Goto Forum Home
Responses

  1. Im still stuck..... , Mar 28, 2004, 4:22 PM
    1. You need to remove the cylinder. , Mar 28, 2004, 8:32 PM

Find more forums on MotorcyclesCreate your own forum at Network54
 Copyright © 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  

Member of the Moped webring
Moped webring Homepage