Re: That would be for.........

by (Login themopedwhiz)
Moped Gurus

 

don is correct

but there is NO plate

the back/engine side of the variator pulley has to be machined or grounded to reduce the interior LIP between the halves

then this same amount has to be replaced on the shaft by a washer before re-asembly { this keeps the front variator and rear drive pullies lined up }

failure to remove a specific amount and using a washer the same thickness { say 0.125 inch , thats 1/8 }

will result in belt failure in a matter of DAY's

TheMopedWhiz

Ride Mopeds..SAve Gas..Have Fun



Posted on May 7, 2005, 5:42 PM
from IP address 66.174.76.203

Respond to this message

Goto Forum Home
Responses

  1. Re: That would be for.......... , May 8, 2005, 4:30 PM
    1. Re: That would be for.......... , May 8, 2005, 11:45 PM
      1. Re: That would be for.......... , May 9, 2005, 3:15 AM
        1. Re: That would be for.......... , May 10, 2005, 12:28 AM
          1. Re: That would be for.......... , May 10, 2005, 1:06 AM

Find more forums on MotorcyclesCreate your own forum at Network54
 Copyright © 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  

Member of the Moped webring
Moped webring Homepage