Throttlen Cable

by chris (no login)


Ok i just gotten a OEM honda needle set for my 78' express. I have the clip in the middle. Now here is my question, how you reinstall the assembley? The only way i can think is you put the needle in the slidetube install the w clip put the spring on and then connect to the thorttle cable? (with the rubber washer inside the throttle cable housing) Now do u put the cable through and the poke it out the side and put it into the notch. Its pretty hard and time consuming. Is this how it is done?..?

Posted on Jun 22, 2005, 5:35 PM
from IP address

Respond to this message

Goto Forum Home

  1. FIXED. chris, Jun 23, 2005, 3:43 PM

Find more forums on MotorcyclesCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement  

Member of the Moped webring

Moped webring Homepage