2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
Tony in Puerto Rico (Login turbonoma) Crosman Forum Member from IP address 184.108.40.206
Took some time out today and went to the shooting range to chrony the iguana hunter with the PowerMax HiPac. I used .177cal. Beeman Gold hollow points 7.2gr. and .177cal. Crosman Hunting domed 7.5gr.pellets. Charged to 1500psi/100bar used with the green spring and power adjuster backed out 3 turns.
Beeman Gold hp 7.2gr. (very erratic velocities)
#3=497fps }these were taken after the gun had been stored for 3 months(dry seals/o-rings?)
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member