Dag Evert's "American Classic"
As mentioned on the forum, heres a picture I took some time back, with natural winter daylight.
A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play,
contact surfaces stoned, and trigger springs somewhat reduced within safe limits.
The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)
-- Dag Evert
with flat top useApril 22 2011 at 9:44 AM
|darren (Login dt45acp)|
Crosman Forum Member
from IP address 18.104.22.168
Response to The pivot is the only part of the linkage that can.
I have seen the valve get pushed backward, significantly, particularly if using a high number of pump strokes.
The cure was to add set screws through the tube and into the valve to keep it in place.
Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member