The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Looks mismatched

April 25 2011 at 8:04 PM
james S  (Login jamesinadvance)
Crosman Forum Member
from IP address 66.226.62.33


Response to Re: easier for me "w/pic"

The walnut looks mismatched and may be as I have walnut from several sources but
the difference isn't as noticeable as in the pic although I wasn't trying to match
the pieces at the time, as much as trying to be frugal with my diminishing supply.
The best shooting 13XX that I referred to had red oak wood which isn't usually used
on guns that I know of but it looked sharp and had the advantage of being easy to lay
hands on. If also is fairly easy to work with good sharp tools.
Oh and that was my first woodwork for an airgun so don't be afraid to try a little DIY

I did recomend that the new owner replace the scope but they kinda liked it go figure

[linked image]

I BRAKE FOR BISCUITS
and TRAINS

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member