The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

If pellet were fired at 800fps from a barrel with...

June 3 2011 at 3:55 PM
Ron  (Login oo7fuzz)
Crosman Forum Member
from IP address 24.167.225.137


Response to What would that be equivilant to?

..rifling which made one turn in 12 inches, the rpm would be 48000.

A conventional Dremel moto Tool has a shaft rotation of around 35000rpm.

Then there are these:
http://en.wikipedia.org/wiki/Flywheel_energy_storage

But a question to the scientifically minded.
We say that a spun pellet may go into precession and nutation while traversing the air at high speed.

To illustrate precession and nutation, we are often directed to observe the gyrating antics of a childs top as it spins about it's axis.

So the question is, would the childs top go into the precession and nutation mode if the top were perfectly ballanced mass-wise and axis-wise?


    
This message has been edited by oo7fuzz from IP address 24.167.225.137 on Jun 3, 2011 3:59 PM


 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member