2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
Are you talking about the lead free ones? I have the 9.6gr .22's and they suck in both of my AS2250's. One is set up with CO2 and the other is set up with 1600psi hpa. They have great speed and will increase your fps by 200-300 fps but they are not accurate, well not accurate for my rifles. I thought it was because they were too light weight but it's not just that, they aren't molded very well. I'll post some pics when I get home later. I could have received a bad batch but I don't think so. At first I tried them in my 1600psi rig and I went from 930fps with a 14.5gr pellet to 1150fps with the super points but never hit the same spot. So when I got my new AS2250 I tried these pellets while the rifle was still stock and they did a little better with less pressure but still never could hit the same spot. If you have a .22 and want to try them email me your address and I'll send you some to try.
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member