The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

Re: Steel Breech nevermind...

June 12 2011 at 8:21 AM
Rodger  (Login 2packrat)
Crosman Forum Member
from IP address 68.51.132.122


Response to Steel Breech nevermind...

I drilled a hole in my plastic breech and tapped it...held my barrel very nicely... a little care will avoid any bumping....Sure the steel breech allows more rigid scope mounting, it ALSO costs $40.00 and weighs like 6 times more than the plastic one...a lot depends on what you are going to use the gun for, too.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member