The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Re: What kind of HPA set-up are you using.....

June 17 2011 at 7:07 AM
Gary  (Login ectomorph1)
Crosman Forum Member
from IP address 71.197.72.35


Response to What kind of HPA set-up are you using.....

Hey Jack

MY XT has the screw in connection, for the
88oz CO2 in the back. It rests on top of the stock.

When I bought the hpa tank, I also purchased a brass
adaptor. The hpa tank comes with a regulator between
the tank and adaptor. I had him set it for 1200 psi.

As for the three screw stake down of the valve,
I hadn't heard about that yet. I went to the
Crosman Airgun Forum Tech section. Checked in
the external tank bulking section and the valve
mod section. I obviously missed it. Even if I
did find it,I don't have access to a drill
press. So I will just be patient, keep doing
my homework, and check with Mac1 today to see
if he can put me on the list.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member