Carl Quick's LiteWieght 2240
So for about the last 24 months, I've had her on a serious diet. Now I am happy to
report that she lost nearly 13 ounces and is feeling so much better. And let me
say one thing, when I pick her up with one hand now she is light as a feather.
Well, almost a feather.
Things I have done so far:
OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.
Re: What kind of HPA set-up are you using.....June 17 2011 at 7:07 AM
|Gary (Login ectomorph1)|
Crosman Forum Member
from IP address 220.127.116.11
Response to What kind of HPA set-up are you using.....
MY XT has the screw in connection, for the
88oz CO2 in the back. It rests on top of the stock.
When I bought the hpa tank, I also purchased a brass
adaptor. The hpa tank comes with a regulator between
the tank and adaptor. I had him set it for 1200 psi.
As for the three screw stake down of the valve,
I hadn't heard about that yet. I went to the
Crosman Airgun Forum Tech section. Checked in
the external tank bulking section and the valve
mod section. I obviously missed it. Even if I
did find it,I don't have access to a drill
press. So I will just be patient, keep doing
my homework, and check with Mac1 today to see
if he can put me on the list.
Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member