The factory screws can be accessed using a square head...August 7 2011 at 9:48 AM
|James S (Login jamesinadvance)|
Crosman Forum Member
from IP address 126.96.36.199
Response to screws again
driver insert held with a small wrench pliers etc. Can't remember the size, it is
the same as commonly used these days in electrical applications. I have a Klien
ten in one screwdriver that has the right size driver insert.
These are not philips screws ,,,either use a flat head or square drive.
If you do go with allen head screws think about using button head screws as the head is
a bit wider than the standard,, it will fill the space better and with a lower profile.
I BRAKE FOR BISCUITS
- #2 Robertson - Glover, Walter on Aug 7, 2011, 4:47 PM
- RE# - buster on Aug 7, 2011, 6:13 PM