The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Oh sorry....

August 14 2011 at 9:57 PM

dan house  (Login dan_house)
Crosman Forum Member
from IP address 71.210.118.180


Response to Not sure I follow, Dan...

off center, the bore will not be centered in the tube.

Photobucket 

my first go round on for shrouding the 397. Because the shroud indexes on the glue joint, its off center relative to the bore.

 



dr_subsonic's pneumatic research lab
[linked image]
the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member