photo toplogo1_zps46807118.jpg

 photo americlps_zpsavfgvdau.jpg

Dag Evert's "American Classic"

As mentioned on the forum, heres a picture I took some time back, with natural winter daylight.
A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play,
contact surfaces stoned, and trigger springs somewhat reduced within safe limits.
The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)
-- Dag Evert

 Return to Index  

oh wait

August 14 2011 at 10:14 PM

dan house  (Login dan_house)
Crosman Forum Member
from IP address 71.210.118.180


Response to You're good. I see...

reread your response.... no the barrel and bore ARE concentric

But slotting the tube and sliding it over the solder joint creates an asymmetrical space in the shroud tube. center line of the shroud is above the center line of the bore, eccentric.

which makes internals,,,, infernal.....

cant tell you how many bits have been blown out thefront from misalignment

  

 



dr_subsonic's pneumatic research lab
[linked image]
the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way

Information presented in this forum is intended for informational purposes only; use at your own risk

Posts made to this forum are soley the opinion of the individual member