The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

check the nose of the check valve

August 30 2011 at 9:53 PM

dan house  (Login dan_house)
Crosman Forum Member
from IP address 71.210.115.114


Response to Re: good point

and make sure the shoulders are square

make sure its round at the tip (reason I say this, is the CV in my 397 had deformed and exhibitied the symtoms you describe)

and check for crud where the CV seats on the valve

 



dr_subsonic's pneumatic research lab
[linked image]
the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member