The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

If it uses the same style valve...

September 1 2011 at 10:16 AM
Phil  (Login Duane30)
Crosman Forum Member
from IP address 69.136.1.121


Response to very cool idea

..., o-ring in the front of the valve (most certain it does), then the factory valve will be fine. The inlet check valve will need to be removed, but other than that all is a go. Of course a new tube is required for PCP application.

When it comes out, I'll examine it more closely...

"Well, I thought it was a rabbit but it turned out to be Bear Grylls in a rabbit hide."

[linked image]

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member