The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Wow, that's pretty sneaky there..

October 2 2011 at 8:18 PM

mav  (Login mav72)
Crosman Forum Member
from IP address 68.7.252.9


Response to hmmm, got my 760 , sidelever might not be as easy as i thought

I guess that's the price you have to pay if you want to go crazy in tricking out your 760... If you have a jig to hold the tube and a drill press it shouldn't be too bad to drill the holes... I'm just wondering if the old holes get in the way of the planned new holes because I've never looked at one with a plan like this.... If everything looks good, you can measure and use marked bands of masking tape as guides before you drill... So you need holes for the front pivot, rear support, trigger sear, and hammer pin... You also need to figure out what you are going to do about a barrel band because I don't know of any that go on allowing for a sideways pump... There may be a clearance problem with the roll pin and barrel also but you probably can use some sort of pin with a curved head on top to contour with the tube... I say, if you're "that good" and up to the task, "Go for it!"

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member