The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

this might be the solution , its my

October 3 2011 at 8:11 AM

robny  (Login robnewyork)
Crosman Forum Member
from IP address 108.21.102.194


Response to Re: hahahaahaha

single biggest obstacle for what im buiding , otherwise i need to replan a whole new design .. i see what you mean about rotating the whole assembly , if it just causes me to need to make a new band , no issue.. im gonna take a serious look tonight , and most likely make the attempt tonight , its either that or I figure out a mechanical solution to pumping , without having a huge pump arm below the gun.. (which would require fabbing metal , bearing hinges, and me going to the sanatarium )

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member