2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
As I mentioned before, you probably can use a Duplex Head Nail (Double Head Nail) that has a comparative size in place of the magnet... I know I've seen some before when I was no longer into airguns.... You probably could sandwich a small "o" ring between the plastic bolt and the bottom head... Then chop off the top head.. If you couldn't find the perfect size, I'm sure you could chuck it into a drill and file it down... This may even work on the 2100...
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member