The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

time cruch

October 18 2011 at 6:58 AM

robny  (Login robnewyork)
Crosman Forum Member
from IP address 108.21.102.194


Response to Looking good Dan!

i think the pressure of the timeline keeps me moving , i finished the new foward trigger assembly last night and had no motivation but i know that i wasted 3 weeks just getting the gun and making the sidelever.Dan went over the top with the 201 and ran outa time So i know it can happen.. right now im "on schedule " but any week long setback would eliminate me from the contest.. Dan put in alot of hours so far,and was methodical in his planning , hence hes soo far along so early this time.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member