The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

We will see

October 24 2011 at 5:29 PM
Good information  (Login jamesinadvance)
Crosman Forum Member
from IP address 66.226.48.192


Response to Riser block for Crosman 1377 breech questions

I hope my attempt works out, if not I may well be calling on one of these vendors mentioned above. I am very much
a do it myself kinda guy and want to try to do this myself first. I'm not set up to do any complicated machine
work but am pretty handy with what I do have so we will see.
As stated before I hope to do a follow up post on this in the near future.

THANKS for the response and interest

I BRAKE FOR BISCUITS
and TRAINS

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member