The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

Muzzle brake

October 26 2011 at 6:45 PM
Dave Rose  (Login DRose)
Crosman Forum Member
from IP address 69.47.140.132


Response to Crosman Titan Question..........

It is a very nice steel metal muzzle brake held on by two grub screws and will slide right off. I read a post about sliding it out about 2" farther on the barrel to make cocking the rifle easier, but I think not seating it all the way on the barrel effected the accuracy for the worse.
Get an improved trigger. Dave

 
 Respond to this message   

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member