The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

off to the side would work.

October 31 2011 at 12:39 PM

dan house  (Login dan_house)
Crosman Forum Member
from IP address 153.90.162.47


Response to I'd say two would be overkill. Having the hammer off to one side...

just need to make it stop much hegher in the tube.

My prime suspect at this point for allowing the hammer to move that much at all is the spring guide.

My 22xx and 13xx guns dont exhibit (or at least as much....) this behaviour. and its essentially the same drive train, excepting the spring termination.

Gonna look at the guide, see if I can get it to stay in place or make a mo' better one (hehe or a third option: maybe I'm not reasseembling it correctly, and thats what allows all that movement.....)

 



dr_subsonic's pneumatic research lab
[linked image]
the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member