2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
Since there are no physical prizes to win, just bragging rights, what would it hurt if there were a tie? There's always next time.
Basically no problem with what you just said, just a few clarifications.
If we're modding a Brand X Model Y gun the part that says X-Y needs to be a part ofthe build. You want a different part that that? Replace it after the build off. If there is no properly ID'd and serial numbered part how do we know you even bought a Brand X Model Y gun in the first place? If it doesn't say "Crosman" on it, is it really a Crosman?
Also, what about the original three categories of Power, Accuracy, and Looks? Do we have these in all classes, or will it be a winner takes all in each class?
Perhaps a "Best of Show" award and some "Honorable Mention" awards?
But if there's less than 10 entries do we need all of these rules? Let's just stipulate the gun and the time limit and forget the rest. Just display your stuff at the end of the build-off to see what everyone did with their Brand X Model Y gun. One big Show and Tell session.
I plink, therefore I am.
This message has been edited by airgunandy from IP address 126.96.36.199 on Nov 18, 2011 2:39 PM
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member