The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

More pics..

November 26 2011 at 8:55 AM
Mark  (Login Specman)
Crosman Forum Member
from IP address 85.211.137.242


Response to Surely this is not right? Any comments appreciated...

Here is a shot of the stainless probe simply pushed into the .177 barrel, no breech to confuse the issue

[linked image]

Here is a brass .177 extended probe

[linked image]

Here is the two probes side by side, not a great picture I am afraid and hardly scientific. Not easy to see but I used the lined paper through the bolt holes to centre.
The brass bolt has more brass behind the handle and doesn't reach so far into the barrel

[linked image]

I'll try to measure the distance between the bolt handles and the o-ring grove as accurate as possible for each probe.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member