The (new) Crosman Forum, your first and last stop for all things Crosman

 photo americlps_zpsavfgvdau.jpg

Dag Evert's "American Classic"

As mentioned on the forum, heres a picture I took some time back, with natural winter daylight. A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play, contact surfaces stoned, and trigger springs somewhat reduced within safe limits. The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)


-- Dag Evert

 Return to Index  

Bolt handle hole is drilled and tapped too far back

November 26 2011 at 6:39 PM
Glover, Walter  (Login Voltar1)
Crosman Forum Member
from IP address 199.96.209.157


Response to Surely this is not right? Any comments appreciated...

All you need is a standard length bolt to correct the oring issue.

Walter....

 
 Respond to this message   

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member