photo toplogo1_zps46807118.jpg

 photo americlps_zpsavfgvdau.jpg

Dag Evert's "American Classic"

As mentioned on the forum, heres a picture I took some time back, with natural winter daylight.
A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play,
contact surfaces stoned, and trigger springs somewhat reduced within safe limits.
The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)
-- Dag Evert

 Return to Index  

One more thing to check.

November 28 2011 at 3:13 PM
Michael Chavka  (Login haywire2)
Crosman Forum Member
from IP address 76.124.146.178


Response to Trouble with bolt on 2240operating rough and now...

Make sure the 8-32 threaded section of the bolt handle is not too long and causing the bolt to bind against the inside of the breech. (ask me how I know) It only takes a tiny bit of the handle passing through the other side of the bolt to cause it to bind.

Regards,
Michael Chavka

Success is not an entitlement.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way

Information presented in this forum is intended for informational purposes only; use at your own risk

Posts made to this forum are soley the opinion of the individual member