The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

don't use drill press

December 6 2011 at 7:27 AM
Martin D. White  (Login MartinDWhite)
Crosman Forum Member
from IP address 65.81.92.226


Response to Could a drill press be used as a light arbor press...

It is possible to use a drill press as an arbor press, but it is bad practice. An arbor press is pretty cheap when compared to a drill press is broken or bent.

$39 for a cheap small one
http://www.use-enco.com/CGI/INSRIT?PMAKA=805-1010&PMPXNO=949902&PARTPG=INLMK3
$454 for a big one
http://www.use-enco.com/CGI/INSRIT?PMAKA=890-8806&PMPXNO=3463255&PARTPG=INLMK3

with a lot of choice in between.

I have a 1 ton (small to medium sized) and use it a lot for than I thought I would.

Martin D. White

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member