The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Discola pistol

December 18 2011 at 3:02 AM
Walterb  (Login walterbajema)
Crosman Forum Member
from IP address 71.231.62.133

After a year or so of being apart and back apart between arival of various parts its finally shootable again. I just need to get a 4-48 tap so i can tap the replacement i got (i got a cothran riser with the old location, and i tapped it 4-40 it stripped) so when i ordered the tube i also ordered the prod trigger ( its real good, not as nice as a p1 tho) but i dont have any grips for it. Anyone got a set i could bum. Kidding, i can pay, or that grip/stock. Ill break out the chrony when/if the washimgton drizzle lets up.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member