The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

1322 long steel breech install..

February 4 2012 at 6:04 PM
richwoods  (Login icufuzz)
Crosman Forum Member
from IP address 72.199.153.119

Sure was easy...only scare was that little breech screw...other than that,no issues...

The scope is a Center Point Multi Dot...choice of 4 reticles...the reticles are bright/clear and in sharp focus...a pleasant suprise compared to some cheap red dots I've used...just need to get some 30mm rings for the 11mm rail and lower the scope down some.

May do some power mods next,but for now I'm going shoot this pistol for awhile.

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]

[IMG][linked image][/IMG]


    
This message has been edited by icufuzz from IP address 72.199.153.119 on Feb 4, 2012 6:06 PM


 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member