The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

plus the torque on the screws

February 11 2012 at 5:16 PM

robny  (Login robnewyork)
Crosman Forum Member
from IP address 98.14.114.201


Response to Re: Sounds like a good test to me, Ron. Thank you for sharing your results. Of course...

might actually be flexing the tube wall ever so lightly so as to create adddition friction between the inner wall and valve ,perhaps?

[linked image]
"i never was much for book learnin"


    
This message has been edited by robnewyork from IP address 98.14.114.201 on Feb 11, 2012 5:45 PM


 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member