The (new) Crosman Forum, your first and last stop for all things Crosman

 photo americlps_zpsavfgvdau.jpg

Dag Evert's "American Classic"

As mentioned on the forum, heres a picture I took some time back, with natural winter daylight. A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play, contact surfaces stoned, and trigger springs somewhat reduced within safe limits. The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)


-- Dag Evert

 Return to Index  

If it didn't bend...

February 16 2012 at 6:55 PM
Phil  (Login Duane30)
Crosman Forum Member
from IP address 74.140.196.166


Response to broken benjamin front sight

..where it broke, just a clean break, epoxy will work just fine.

Or, you can file where it broke flat, then solder or epoxy a piece of flat stock on. You then can file it to shape.

"The majority of things in our lives are created by folks no smarter than the rest. Afterall, the world is comprised, and operated by C average people intellctually, academically, and morally. These people are often the great pioneers that set the precedent for what excellence should be."

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member